1978-1991 Johnson Evinrude 20" Lower Unit 85 88 90 100 110 115 140 HP 1 YEAR WTY

• 20 Inch Driveshaft 
• Single piece driveshaft 
• Fully resealed 
• Extended Warranty (see below for more info)

• Shifts and spins smoothly without binding
• Shafts checked for straightness
• Driveshaft splines show little to no wear
• Gears & clutch are in good condition with light wear on the clutch surfaces 
• Freshwater Condition
• Repainted
• New Impeller installed
• Fully Resealed & Pressure checked to 12 PSI

Driveshaft splines: 20

Propeller shaft splines: 13

Driveshaft length from the top of the water pump to top of the shaft: 19"

Please add oil before use. This unit is shipped empty. 

This part is sold with a 1 year working warranty.  This warranty is upheld by Southcentral Outboards. If you need to use, or have any questions regarding this warranty, you must contact us directly.

Location: Southcentral Outboards, Altamont, Illinois

1978-1991 V4 outboards.  Please note that from 1985-1991, Johnson and Evinrude made 2 different styles of V4.  The 60 degree, or crossflow engine ran through all of these years.  Starting in 1985, they also made a 90 degree Looper engine, which had a bigger gearcase.  The units will interchange, but you'd need a different prop in order to run this on your larger 90 degree engine.  This will, however, be an exact interchange for all of the 1978-1991 60 degree crossflow engines.

This unit does have a single-piece driveshaft. 

We have provided this cross-reference with the resources we have available in regards to fitment. This most likely will not fit every model for the years and horsepowers we have listed. We urge you to make sure this is the exact item you need by matching the part number to what is required for your motor. If you need help doing so, please contact us prior to purchasing and we would be happy to help!