Mercury 1988 & Below Bravo I Lower Unit 1.25:1 Ratio 6 MONTH WTY

• This unit was removed from a freshwater setup. 
• It spins smoothly with no binding and the prop shaft is straight. 
• The unit had clean oil that was free of metal or water. 
• The paint is a little banged up 
• There is some damage at the rear of te unit above the prop shaft and this should not affect performance
• The unit has been opened and flushed and inspected. 
• The gears and clutch are in good condition along with the carrier and bearings. 
• We were unable to pressure test without the upper gearcase. 
• The Driveshaft measure 7" from top of the shaft to the top plate. 
• There are 15 splines both on the driveshaft and the prop shaft.
• Please refer to the photos so that you can observe both what is included in this listing and the condition that it is in.  
  
  Please note:  This unit will be drained of all oil prior to shipping and you will need to replace this oil prior to use. 

General Information

• Freshwater condition
• Opened & Inspected
• Professionally Cleaned
• Shafts checked for straightness
• 6 Month mechanical warranty

Criteria to validate your 6 month warranty:

• Core must be of equal or greater value
• Cannot be locked up - driveshaft must spin
• Up to 30 days from the date of purchase to send in your core
• Covers mechanical aspects ONLY
• Warranty begins from date of purchase

We offer a 45-day return policy so you can purchase this item with confidence. If you have any issues with the product, please reach out to us and we would be happy to help resolve any issue that may occur. Please be absolutely sure this is the correct one for your motor prior to purchasing.

If you purchase this item incorrectly or change your mind, we will accept a return within 45 days however, we will charge our initial shipping cost and a 20% restocking fee. If you have any questions, please contact us.

Location: Southcentral Outboards, Altamont, Illinois

We have provided this cross-reference with the resources we have available in regards to fitment. This most likely will not fit every model for the years and horsepowers we have listed. We urge you to make sure this is the exact item you need by matching the part number to what is required for your motor. If you need help doing so, please contact us prior to purchasing and we would be happy to help!